When the first intersection, you see the dawn of victory, you will once again welcome to the intersection.Д¬ollector - this is four devices, used as a passive repeater to help determine the location of the object. Remember, in the operation of the device, the calm relaxed people who will do better than the rigid tension! When you enter the radio frequency energy line, the antenna rod will naturally cross. Everyone needs to find the best suited to their distance. Hand-held rod antenna, the antenna should point to the front bar, parallel to each other and separated by 8-18 inches away. Under normal circumstances, holding the antenna rod to stabilize and balance, waist height, and slightly in front of the operator. Antenna rod is designed to the operator that he / she has entered the power transmission between the sensor and the target line. Rod antenna - antenna rod powered by the power module. When connected to functional modules, avoid contact with each other so that the antenna rod, because it can cause the battery short circuit. When not in use, the antenna rods unplug from the power module! If the antenna rod inserted in the power save module, it will cause the battery (9 volts) leakage. Rod antenna socket into the power module, power module open. To replace the 9 volt battery, only need to rotate out of the bottom cover, open the module. If the light is dim or bright light, you need to replace the battery. If the top of the lights lit, the battery intact. At the top of the 'PUSH' button to display battery status. Power Module - This device is designed to power the antenna rod. Power cable coaxial cable, and SCANMASTER the output connection. Power sensor - the component responsible for the two copper rod into the ground through the scan the selected signal to the ground. Too large fuse may damage SCANMASTER, in this case, the lifetime warranty will be void! Please note that the scanner is connected to the power cord and battery, must pay attention to polarity! If the polarity reversed, the fuse will burn, this time, we must replace the fuse! Fuses must be followed exactly the same as the original! The correct size is 1 amp-120/250 volt-3AG slow down the fuse. Reversed polarity will damage the battery charging and / or shorten the battery life (3-5 years). Connect the charger and battery, note polarity. SCANMASTER apparatus equipped with the battery through a small charger. Under normal circumstances the battery can be used continuously for 18 hours. When the voltage is low, the frequency display performance unstable. Battery voltage by the circuit device continuously monitors the scanner. The device design is simple, yet powerful. SCANMASTER - This is the main components of the scanner. Ultra deep underground metal detector (U.S.)

Scanmaster scanner